Preparation:
- Configure ControlbyWeb Relay’s network.
Follow controlbyweb relay’s manual to setup network.
Before add Integration, make sure controlbyweb relay devices is connected to Internet.
And we shall be able to open controlbyweb device’s web UI.
- take a photo or write down controlbyWeb device’s Serial number
Device Serial Number can be found on the label of device.
For example: In bellow device label,Serial number is 000CC807EA05
Add ControlbyWeb Integration
- Login Entrio Web Portal: portal.entrioai.com,
Navigate to Settings —> Integration
Click Add Device and Enter Device Serial Number, Device Serial Number can be found on the label of device.
- Click Generate CRT Token button and we shall see a token display, copy the token.
- Then navigate to the ControlbyWeb Device web UI. (Assuming your PC and ControlbyWeb Device is in the same LAN)
- Click General Settings —>Advanced Network
- Scroll to Remote Services, select Certified Request Token option
- Paste the CRT token we just copied.
- Scroll down, click submit button and wait a few seconds.
- Switch back to Entrio Web Portal and Click Continue to Device Configuration button.
Then Click Check Device Status button
If Device was registered to ControlbyWeb Cloud successfully, we shall see: Device is online and ready!
- Click Add Device to continue
Select Digital Intercom device to link with, or you can skip this step and do this later.
- Once done, you shall see Integration shows under Integration List
Now you can use your Mobile App to swipe open door and it will trigger the web Relay to send Relay command
